|
[Sponsors] |
February 2, 2024, 09:28 |
Shuttlecock Simulation Issues
|
#1 |
New Member
Join Date: Feb 2024
Posts: 3
Rep Power: 2 |
Good Afternoon,
I am attempting to simulate the flow over a shuttlecock but i am having issues with the geometry 'breaking' in the cfd-post section. I have attached an image. Some info: Currently the enclosure is defined as a fluid domain and the shuttle head and body as solid domain. The top two components in the default domain (Default Domain Default and Default Fluid Solid Interface Side 1) seem to be the ones 'breaking' but in Domain 1 (the solid domain) they appear fine but do not give a drag reading. Any advice on what to look at would be much appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NREL S809 Aerofoil Simulation - Stall and Drag Issues | mme1998 | CFX | 1 | March 3, 2021 16:24 |
Convergence issues for a 3D Centrifugal pump simulation using ANSYS CFX | enr_venkat | CFX | 7 | August 31, 2016 18:58 |
Memory issues in full annulus simulation | evan247 | CFX | 5 | March 16, 2016 10:40 |
Convergence issues in wind tunnel simulation | cldox | FLUENT | 0 | November 18, 2015 11:41 |
CFD Simulation Issues with Car Outline | Active.Aero.Fiero | FLUENT | 3 | November 8, 2010 01:25 |