|
[Sponsors] |
March 27, 2008, 16:06 |
density problem
|
#1 |
Guest
Posts: n/a
|
Guys,
I defined a new material in CFX with variable density and viscosity by using CEL. I did plot the density and viscosity in CFX-Pre which look great. the problem is a simple liquid flow in duct. the inlet BC is mass flow rate and static temp. the outlet BC is static pressure. the wall is non-slip with a constant temp. When I tried to run the case, I got a fetal error which is as follows, Fetal Bounds Error Detected ----------------------------- Variable: Density Details of Error ---------------------------- Error detected by routine: MAKDAT CDANAM = LVAR CDTYPE = INTR ISIZE = 95 CRESLT = OLD Anybody knows where the problem is? thanks a lot snowshovel |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
estimation of density in cavitating problem | rem | Siemens | 1 | October 21, 2008 01:07 |
Negative density problem. compressible flow | Karl | Siemens | 2 | July 10, 2008 16:41 |
Problem on high density ratio in Level Set method | Kai Yan | Main CFD Forum | 10 | December 25, 2007 06:12 |
Roe-averaged Density | Nishikawa | Main CFD Forum | 19 | April 3, 2000 23:08 |
extremely simple problem... can you solve it properly? | Mikhail | Main CFD Forum | 40 | September 9, 1999 09:11 |