|
[Sponsors] |
May 8, 2008, 09:49 |
boundary conditions - help needed!!!
|
#1 |
Guest
Posts: n/a
|
Hello, everyone
I am doing permeability testing in textiles using CFX 10.0. I used TexGen to create unit cell and I also used it for meshing. When I input meshed geometry which is block and yarns inside it and tried to create boundary conditions I got a problem. I cannot separate faces in block so I can create input pressure and output pressure. So I was trying to find another option, maybe to create another surface above my unit cell so I can create boundary conditions there. I still don't know how to do this. If you have any idea, please let me know. I will be very thankful for any reasonable advice. Kind regards, Elena |
|
May 23, 2008, 03:05 |
Re: boundary conditions - help needed!!!
|
#2 |
Guest
Posts: n/a
|
Elena,
Could you please elaborate the problem little more? Regards Mehul |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
Natural Convection Boundary Conditions, tips or advise needed ! | Logan Page | ANSYS | 0 | September 27, 2010 18:44 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Help needed with boundary conditions | JP | FLUENT | 1 | October 2, 2008 02:30 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |