|
[Sponsors] |
August 26, 2008, 15:06 |
Openings and compressible flow
|
#1 |
Guest
Posts: n/a
|
Hi
I have set up a case in which I have opening & total pressure at the inlet, and opening & static pressure at the outlet. I am running compressible simulation. Is it ok to use openings at both ends with compressible simulation? If I do not use opening on either end, I get a message from solver stating "A wall has been placed the outlet/inlet". Under what circumstances one can ignore this message. Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Openings and compressible flow | underGroundMan | Main CFD Forum | 1 | August 27, 2008 02:58 |