|
[Sponsors] |
March 23, 2009, 21:16 |
boundary conditions for hub and shroud
|
#1 |
Member
^_^
Join Date: Mar 2009
Posts: 36
Rep Power: 17 |
Hey guys,
I am simulating a centrifual pump, but not so clear about the boundary conditions. If it is a closed impeller, we should set hub and shroud as "relative velocity =0"? If open impeller, then hub and shroud are walls with "absolute velocity=0“? Is this understanding right? Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
specifying tip clearance at the shroud | Mohammad | CFX | 1 | December 25, 2008 07:06 |
boundary conditions - axial compressor | Ramesh.K | FLUENT | 0 | April 6, 2007 21:55 |
[Q] Boundary conditions in Turbomachinery | ghlee | Main CFD Forum | 3 | July 23, 1999 17:05 |