|
[Sponsors] |
FSI: change material parameters before restart |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 29, 2010, 09:31 |
FSI: change material parameters before restart
|
#1 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 22 |
I made a restart on my FSI simulation and at the same time changed the Youngs modulus and stiffness of the solid domain (just edited the .mf file and added the new MP,DENS and MP,EX commands).
However, I got a warning that it is a "non-standard behaviour" to change material parameters between load steps. Is there a "standard behaviour" to do this, or arent you supposed to make a restart with new material parameters? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
the material parameters depending on temperature | Jason | CFX | 4 | December 22, 2006 19:54 |
Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
About create new material | jasonchang | CFX | 3 | May 18, 2006 21:07 |
how to change the material properties | Marco | CFX | 7 | September 22, 2005 18:53 |
Paraffin Phase Change Material | Sandra | CFX | 1 | April 27, 2005 00:49 |