|
[Sponsors] |
Transient Simulation Taking Very Long TIME!!!! Help |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 7, 2011, 08:19 |
Transient Simulation Taking Very Long TIME!!!! Help
|
#1 |
New Member
phil fenna
Join Date: Feb 2011
Posts: 14
Rep Power: 15 |
I'm running a transient simulation of my water tank, the mesh has 500,000 elements, the tank should take about 3000 seconds to fill up but when i specify an interval of 10s it takes almost 2 days to run! Is this normal? or is there a way to increase the speed of simulations?
Also when running intervals of 10s my RMS Courant number is about 150 which is way too high, is this down to my interval of being to high at 10s? Is there a way to calculate a good time interval? Any help will be greatly appreciated! Thanks Phil |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TimeVaryingMappedFixedValue | irishdave | OpenFOAM Running, Solving & CFD | 32 | June 16, 2021 06:55 |
Missing math.h header | Travis | FLUENT | 4 | January 15, 2009 11:48 |
MFX output of simulation time | Richard | CFX | 0 | October 10, 2008 09:50 |
Transient Time Step for supersonic flows | CP | CFX | 1 | November 12, 2007 16:22 |
Charts for transient simulation | Anurag | CFX | 2 | March 28, 2005 12:09 |