|
[Sponsors] |
March 30, 2011, 11:48 |
Reaction rate too slow
|
#1 |
New Member
K. D.
Join Date: Feb 2011
Posts: 6
Rep Power: 15 |
Hello.
I try to simulate combustion in a porous structure using eddy dissipation model. Convergence is okay, but the reaction rate is too small. The combusion should be (nearly) completed at the burner outlet, but the ch4 mass fraction is only half the inlet value. Is there a way to speed up the reaction? THANK YOU A LOT IN ADVANCE! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Segmentation fault in running alternateSteadyReactingFoam,why? | NewKid | OpenFOAM | 18 | January 20, 2011 16:55 |
UDF for catalyst volumetric reaction, temperature overshoot though rate is small | elmcmaster | FLUENT | 0 | October 11, 2010 09:37 |
surface reaction rate with udf | yellow-stuff | FLUENT | 4 | January 29, 2010 12:53 |
UDF changing the rate exponent of a reaction | Stefan H | Fluent UDF and Scheme Programming | 0 | September 16, 2009 13:20 |
chemical reaction - decompostition | La S. Hyuck | CFX | 1 | May 23, 2001 00:07 |