|
[Sponsors] |
January 31, 2012, 08:17 |
Not rotating hub at inlet and outlet
|
#1 |
New Member
Morteza Hamzehzadeh
Join Date: Oct 2011
Posts: 2
Rep Power: 0 |
Hello
I am trying to simulate the rotor of the radial inflow turbine. I create the geometry of rotor with Bladegen and create the mesh with Turbogrid. When I create the rotor geometry, two extended zones are created at inlet and outlet of rotor. The hub of this zones, shouldn't rotate. I know that I must set these portions of hub as counter rotating wall but I don't know how separate these portions from the hub in CFX or Turbogrid. Please help me. Thanks so much |
|
Tags |
counter rotating wall, hub, radial inflow turbine, rotor |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pulsatile pressure inlet with pressure outlet | a.lynchy | FLUENT | 3 | March 23, 2012 13:45 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
steam flow in a pipe driven by a pressure gradient between inlet and outlet | SalvoCalvo | COMSOL | 0 | March 11, 2010 06:52 |
VOF Outlet boundary condition in cfd - ace | JM | Main CFD Forum | 0 | December 15, 2006 08:07 |
what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |