What mean by "from mass constraint" in plasma model

tomchiah · November 21, 2023, 09:40

Hi all,

I noticed under plasma model, for the settings of each species it has the tick option of 'from mass constraint' may I know what is this means? The screenshot is shown in the attachment Screenshot 2023-11-21 190026.jpg

aminem · December 26, 2023, 06:27

It's mean simply calculated by X(N)= 1-X(1)-X(2)-X(3)-...-X(N-1). X(1) to X(N-1) are masse fraction of other species.

tomchiah · December 26, 2023, 08:06

I noticed, that by setting different species to mass constraint can result as converging error. So far what I know is to set the largest species to mass constraint is the correct way of doing it.

aminem · December 27, 2023, 02:23

You should put only one specie to mass constraint

tomchiah · December 27, 2023, 07:27

But is the one species must be the largets one? That is what I am trying to ask.

November 21, 2023, 09:40	What mean by "from mass constraint" in plasma model	#1
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 2	Hi all, I noticed under plasma model, for the settings of each species it has the tick option of 'from mass constraint' may I know what is this means? The screenshot is shown in the attachment Screenshot 2023-11-21 190026.jpg

December 26, 2023, 06:27		#2
aminem Member amine Join Date: Jan 2014 Location: FRANCE Posts: 84 Rep Power: 12	It's mean simply calculated by X(N)= 1-X(1)-X(2)-X(3)-...-X(N-1). X(1) to X(N-1) are masse fraction of other species. tomchiah likes this.

December 27, 2023, 02:23		#4
aminem Member amine Join Date: Jan 2014 Location: FRANCE Posts: 84 Rep Power: 12	You should put only one specie to mass constraint tomchiah likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the height of the stream in the free channel	kevinmccartin	CFX	12	October 13, 2022 21:43
[swak4Foam] swakExpression not writing to log	alexfells	OpenFOAM Community Contributions	3	March 16, 2020 18:19
Low torque values on Screw Turbine	Shaun Waters	CFX	34	July 23, 2015 08:16
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 17:44

December 26, 2023, 08:06		#3
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 2	I noticed, that by setting different species to mass constraint can result as converging error. So far what I know is to set the largest species to mass constraint is the correct way of doing it.

December 27, 2023, 07:27		#5
tomchiah Member Chiah Zi Jing Join Date: Oct 2023 Location: Xiamen University Malaysia (XMUM) Sepang, Malaysia Posts: 38 Rep Power: 2	But is the one species must be the largets one? That is what I am trying to ask.