 |
 |
 |
|
|
|
[Sponsors] | ||||
September 5, 2018, 17:10
|
Gas Turbine Combustion using SAGE
|
#1 |
|
New Member
Touqeer Anwar Kashif
Join Date: Jan 2018
Posts: 1
Rep Power: 0  |
Hi Everyone,
I have been trying to setup a steady state non premixed gaseous fuel(natural gas) gas turbine combustor simulation in CONVERGE CFD(v2.3), using SAGE detailed chemistry model. Each and everytime I run this case, the temperature in the Combustor goes beyond 3500K and stays close to that value indicating that fuel is burning at that temperature, while the Adiabatic flame temperature for natural gas is less than 2500k. I have tried multiple combinations, chaning the location of source, mapping general flow cases, but nothing seems to work Is there any specific property in SAGE that I should change ? |
|
|
|
|
| Tags |
| combustion, gas turbine, sage |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| Combustion simulation and SAGE settings | Owain_Parry | CONVERGE | 6 | January 21, 2017 09:56 |
| CFD analysis on wind turbine rotor | Ken (Wind Turbine CFD Super Rookie) | Main CFD Forum | 45 | February 9, 2016 14:07 |
| gas turbine combustion chamber cold flow simulation | chawane | FLUENT | 1 | January 21, 2016 10:56 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
Threaded Mode
