|
[Sponsors] |
September 7, 2021, 03:54 |
DWI,spray modeling setup
|
#1 |
New Member
Lynn
Join Date: Jan 2021
Posts: 12
Rep Power: 5 |
Hello everyone,
I have some questions about spray modeling setup when adding the water injector in a disel engine? The engine have both disel injectors and water injectors, except the setup of Injectors, how the setup of General, Collision/Breakup/Drag, and Wall Interaction should be changed? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Taylor Couette Setup and Boundary Conditions | DaSh | OpenFOAM Pre-Processing | 2 | September 28, 2017 12:02 |
[ICEM] surface/curve mesh setup | Studi | ANSYS Meshing & Geometry | 15 | November 12, 2014 00:32 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
May Focus Area: Turbulence Modeling | Jonas Larsson | CFD-Wiki | 0 | May 2, 2006 11:48 |
Extrusion Modeling | Elliot Schwartz | Main CFD Forum | 1 | September 11, 1998 19:08 |