|
[Sponsors] |
April 3, 2024, 03:31 |
In-cylinder pressure with CFD data Overlap
|
#1 |
New Member
ibrahim
Join Date: Jun 2018
Posts: 13
Rep Power: 7 |
Hello everyone,
With Converge CFD, I am working on the combustion analysis of a diesel engine as a closed cycle. In other words, I am working for the case where the valves are closed. I am trying to overlap the CFD results with the in-cylinder pressure graph at the time of compression, but I could not get it to overlap as I wanted. I checked my compression ratio for this. I even reduced the compression ratio to the effective compression ratio. Still no overlap occurred. While doing research for this, I learnt that specific volume and specific pressure values are effective. However, I do not know how to change these values, is there anyone who can help me with this? Translated with DeepL.com (free version) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
viscosity udf don't use correct temperature and strain rate | rezvani | Fluent UDF and Scheme Programming | 8 | May 27, 2021 05:40 |
question regarding LES of pipe flow - pimpleFoam | Dan1788 | OpenFOAM Running, Solving & CFD | 37 | December 26, 2017 14:42 |
CFD Online Celebrates 20 Years Online | jola | Site News & Announcements | 22 | January 31, 2015 00:30 |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |