|
[Sponsors] |
July 13, 2012, 12:43 |
AutoGrid5 Axial Turbine Meshing Error
|
#1 |
New Member
Zoe Burton
Join Date: Aug 2011
Posts: 10
Rep Power: 14 |
I am currently meshing a last steam turbine stage in AutoGrid5. I have generated meshes using the Basic Mode but have encountered an error as there is a significant overlap between the stator outlet and rotor inlet - shown in attached image and I'm getting the error "overlap in row: row2". I assume this stems from the automatic definition of the stator/rotor interface but I don't know how to fix it.
I imported the stator and rotor blade surfaces with accompanying single curve defining the hub and another single curve defining the shroud from an .igs file create in Solidworks. Does anyone have any suggestions on how I can fix this? Thanks in advance Zoe |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
polynomial thermophysical properties II | sebastian | OpenFOAM Running, Solving & CFD | 54 | November 21, 2019 07:12 |
Accessing phi from a fvPatchField at same patch | johndeas | OpenFOAM | 1 | September 13, 2010 20:23 |
checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 12:34 |
error while running paraFoam! | padmanathan | OpenFOAM | 9 | October 13, 2009 05:17 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |