|
[Sponsors] |
March 3, 2015, 18:30 |
AutoGrid Mesh with Extremely Low Run-up
|
#1 |
New Member
Brian
Join Date: Feb 2015
Posts: 15
Rep Power: 11 |
Hello,
I'm working on meshing a compressor blade with an extremely low run-up from the inlet to the LE (maybe space for 8 or 9 cells). This is causing some issues with the B2B grid, very poor orthogonality and aspect ratios, I think due to the O4H topology. Is there a good way to solve this issue without simply having a longer run-up? Thanks. |
|
Tags |
autogrid, meshing, numeca |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[snappyHexMesh] problems generating clean mesh | Christian_tt | OpenFOAM Meshing & Mesh Conversion | 2 | June 20, 2019 05:39 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[ICEM] Low quality mesh | Memme | ANSYS Meshing & Geometry | 1 | May 25, 2012 02:02 |