 |
 |
 |
|
|
|
[Sponsors] | ||||
Help for Autoblade Fitting while export the geomturbo file |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 15, 2016, 07:22
|
Help for Autoblade Fitting while export the geomturbo file
|
#1 |
|
New Member
Chao Man
Join Date: Jan 2016
Posts: 1
Rep Power: 0  |
Hi, everyone,
Now I am optimizing a centrifugal compressor with Design 3D. The periodicity of the blade in the target geomturbo file is 12. After I finished the fitting work, I export the paramitric geomtry and then check the periodicity in the geomturbo file. I found that the periodicity is default number 4. This troubles me while the following step of CFD-Screening. How can i get the correct periodicity of the blade while export the geomturbo file? Who know the answer of this problem? Any help will be welcome. |
|
|
|
|
| Tags |
| auboblade |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wmake compiling new solver | mksca | OpenFOAM Programming & Development | 14 | June 22, 2018 06:29 |
| [Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 17:18 |
| pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
| ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
| DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |
Threaded Mode
