|
[Sponsors] |
Omnis turbocompressor tutorial: Initial solution error |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 14, 2022, 03:25 |
Omnis turbocompressor tutorial: Initial solution error
|
#1 |
New Member
Johan M
Join Date: May 2021
Posts: 25
Rep Power: 5 |
Hi everyone I had been doing the turbocompressor tutorial from the Omnis user guide. I had encountered a ''Cannot compute initial turbomachinery solution'' error when trying to run the simulation, seen attached.
I have checked the initial conditions against the user guide values several times but have still bee unable to spot the error. I would appreciate any assistance regards Johan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Maximum number of iterations exceeded chtmultiregionsimpleFoam | Moncef | OpenFOAM Running, Solving & CFD | 28 | July 13, 2020 14:26 |
laplacianFoam with source term | Herwig | OpenFOAM Running, Solving & CFD | 17 | November 19, 2019 13:47 |
chtMultiRegionSimpleFoam: maximum number of iterations excedeed. | Nkl | OpenFOAM Running, Solving & CFD | 19 | October 10, 2019 02:42 |
checking the system setup and Qt version | vivek070176 | OpenFOAM Installation | 22 | June 1, 2010 12:34 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |