[berkegk]

Hello CFD-online forum,

I am reaching out to seek your assistance regarding a simulation I am conducting in the Floefd program. Specifically, I am attempting to simulate the autoclave and analyze the temperature variations of the air within it over time.
To provide you with a better understanding of my progress, I have attached the relevant images showingcasing the data I have collected thus far. However, I am encountering a challenge due to the absence of heater data. Consequently, when I introduce a heat source into the system, the temperatures tend to escalate to exceedingly high levels.
I kindly request your guidance on how to address this issue as I currently lack any data pertaining to heat sources. Your expertise and support in resolving this matter would be greatly appreciated.
Thank you in advance for your assistance. I eagerly await your response.