|
[Sponsors] |
changing a boundary condition during simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 17, 2012, 10:22 |
changing a boundary condition during simulation
|
#1 |
New Member
half rho vsquared
Join Date: Feb 2012
Posts: 19
Rep Power: 14 |
How do I change the boundary conditions at pre-set times during a simulation?
For example, during a 10 sec simulation I want to change a boundary from stagnation pressure to symmetry at 5 seconds to effectively act as a valve and close off that boundary halfway through the run. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Resolved: Changing boundary condition with UDF according to pressure outlet boundary | alpemre | Fluent UDF and Scheme Programming | 12 | February 24, 2014 10:18 |
Time changing boundary condition | jasper558 | CFX | 1 | August 24, 2011 18:43 |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 11:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |