 |
 |
 |
|
|
|
[Sponsors] | ||||
May 23, 2021, 05:03
|
stl model cannot be scoured
|
#1 |
|
New Member
Frankey
Join Date: May 2021
Posts: 3
Rep Power: 5  |
Hello, everyone.
I’m currently doing sediment scouring. I have created a stl model to import. The properties of the model are set to packed sediment and the diameter is 0.001m. Meanwhile, the boundary conditions are set for fluid to enter from one side of the model and outflow from the other side. However, the simulation found that the volume of fluid 1 keeps decreasing, the model cannot be scoured, and the sediment content does not decrease but increases  . I have tested the stl model with Magics and there is no problem.Have any experts encountered similar problems, please give me some suggestions and help. Thanks in advance |
|
|
|
|
 |
| Tags |
| sedimet scour with stl |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
| [swak4Foam] swakExpression not writing to log | alexfells | OpenFOAM Community Contributions | 3 | March 16, 2020 18:19 |
| How to create inlet/outlet/wall STL files from a STL CAD model | Gentible | Mesh Generation & Pre-Processing | 1 | June 23, 2015 10:18 |
| manualInjection model in sprayFoam | Mentalo | OpenFOAM Running, Solving & CFD | 1 | April 2, 2014 09:29 |
| Stl Model and Model after preprocessor are not the same !!! | AttaponC | FLOW-3D | 2 | September 30, 2009 23:54 |
Linear Mode
