|
[Sponsors] |
March 22, 2023, 14:31 |
baffles in flow3d
|
#1 |
New Member
Eli
Join Date: Jul 2022
Location: Canada
Posts: 13
Rep Power: 3 |
Hi everyone
I hope you are doing great I am modeling an open channel spillway and I want to monitor the flow rate in the entrance of my channel. I have put baffles right in the entrance of my channel using flux surface tab but I don't know where should I find the results of my baffles. is it in the flow3d post? I really appreciate your help. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
interFoam case mesh with baffles crushed | ves | OpenFOAM Running, Solving & CFD | 0 | December 16, 2020 15:08 |
SimpleFoam & Theater | jipai | OpenFOAM Running, Solving & CFD | 3 | June 18, 2019 10:11 |
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
about modelling of baffles in Flow-3D | tecmia | FLOW-3D | 0 | September 24, 2012 09:27 |