|
[Sponsors] |
How to create mesh block for curved channel in FLOW3D? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 17, 2024, 09:12 |
How to create mesh block for curved channel in FLOW3D?
|
#1 |
New Member
Murali Krishnamraju
Join Date: Jan 2022
Posts: 10
Rep Power: 4 |
I am trying to simulate flow in a curved channel in FLOW-3D. But I am struck at creating the mesh block. As shown in the figure, the mesh block is coming as a rectangle, not aligning with the curved channel. The initial water level is also coming over the entire mesh block instead of only in the channel.
How can I correctly create the mesh block and give the boundaries for the curved channel, as shown above? Access figure with this link: https://drive.google.com/file/d/1fuz...8Bm7wFwqc/view |
|
Tags |
flow 3d hydro, flow 3d post, flow3d, mesh 3d |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Heat transfer in 2D ribbed channel: ideas to address the mesh | jmhaque | ANSYS Meshing & Geometry | 5 | March 31, 2024 10:54 |
[Other] splitMeshRegions does not create interface patch between regions | fsan | OpenFOAM Meshing & Mesh Conversion | 10 | June 6, 2022 05:56 |
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
[ICEM] Replay not working properly - Creating the mesh for Free Block. | Wingman | ANSYS Meshing & Geometry | 4 | January 17, 2017 03:57 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |