 |
 |
 |
|
|
|
[Sponsors] | ||||
July 7, 2015, 22:27
|
boundary conditions
|
#1 |
|
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13  |
I have a geometry in which the water falls under gravity and out from the bottom, the air is exiting from a pressure outlet at the top.
How do i make the water escape from the bottom exit alone, if I make it a pressure outlet as well there is air escaping from that outlet too which is not what i want. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
| Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 08:30 |
| GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source | silvan | CFX | 3 | June 16, 2014 10:49 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
