|
[Sponsors] |
July 29, 2016, 11:56 |
Multiphase Inlet Setup
|
#1 |
New Member
Peter
Join Date: Jun 2016
Posts: 10
Rep Power: 9 |
Hi,
I am trying to set the inlet to a specific phase (nitrogen at Inlet) to simulate mixing with air However the options for volume fractions etc are not showing up.. giving the message "This page is not applicable under current settings" I have enabled multiphase VOF.. is there any obvious setting I am missing to enable this page? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dsmcFoam setup | hherbol | OpenFOAM Pre-Processing | 1 | November 19, 2021 01:52 |
"Pressure Inlet" Boundary Setup | Wijaya | FLUENT | 15 | May 18, 2016 10:08 |
UDF profile: Fluent method for coupling inlet and outlet | I-mech | Fluent UDF and Scheme Programming | 0 | May 10, 2014 10:36 |
Inlet Velocity in CFX | aeroman | CFX | 12 | August 6, 2009 18:42 |
Inlet diffuser of ramjet | Mohammad Kermani | Main CFD Forum | 25 | December 29, 2000 18:46 |