[gzsakuraz]

I have the question, will define_profile value in UDMI will change when UDMI in Execute at end change?
Because I want heatflux to be updated in every time step
*the red

please help me

DEFINE_EXECUTE_AT_END(execute_at_end)
{
Domain *d;
face_t f;
Thread *t, *t1;
int Zone_ID = 62; /* Zone Id can be seen in the Boundary Conditions Panel, ice outer = 42 */
d = Get_Domain(1);
cell_t c;
int x =0;
real A[ND_ND]; real area; real totalarea=0;
t = Lookup_Thread(d, Zone_ID);
real v=15.0; /*input wind speed*/
real temp=273.15-273.15; /*ambient temp - zero celsius*/
real humid=0.0;/*input humidity*/
real p1 = (6.11176750+0.443986062*pow(temp,1)+0.143053301*po w(10,-1)*pow(temp,2)
+0.265027242*pow(10,-3)*pow(temp,3)+0.302246994*pow(10,-5)*pow(temp,4)
+0.203886313*pow(10,-7)*pow(temp,5)+0.638780966*pow(10,-10)*pow(temp,6))*100;/*put to the power function*/
real evaporate = ((0.089+0.0782*v)*(p1-humid*p1)/(2450000)); /*kg per area per second*/
real heat = 2450000*evaporate;
real current_time;
current_time = CURRENT_TIMESTEP;
int z=0; int y=0; int p=0; int ab=0; real limitmass=0;
real totalmass =0;
begin_f_loop(f,t){
t1 = THREAD_T0(t);
int ttt=THREAD_ID(t1);
c=F_C0(f, t);
if(ttt==40){
if(C_LIQF(c,t1)>=1.0){
x=x+1;
F_AREA(A,f,t);/*area vector on the surface*/
area = NV_MAG(A);
if(C_UDMI(c,t1,1)<area*1.5*0.001*C_R(c,t1)){ /* check if it is above the limit of evaporation*/
F_AREA(A,f,t);/*area vector on the surface*/
area = NV_MAG(A);
real areaabs=fabs(area);
real mass = evaporate*areaabs*0.5; /*in kg*/
totalmass=mass+totalmass;
C_UDMI(c,t1,1)=C_UDMI(c,t1,1)+mass; /*collect cumulative mass*/
F_UDMI(f,t,2)=-heat; /*collect the position where heat flux must be applied*/
/*make sure sum not exceed*/


}
else{y=y+1; F_UDMI(f,t,2)=0;} /*no evaporative heat flux applied*/
}
}

} end_f_loop(f,t)


}

DEFINE_PROFILE(heatfluxkrub,thread,i)
{

face_t f;
begin_f_loop(f,thread){
F_PROFILE(f,thread,i) = F_UDMI(f,thread,2);
end_f_loop(f,thread)
}
}