UDF received a fatal signal（segmentation fault） -- CFD Online Discussion Forums

September 28, 2018, 09:13	UDF received a fatal signal（segmentation fault）	#1
Lxy2018 New Member Li Xiaoying Join Date: Jun 2018 Posts: 8 Rep Power: 7	Hi！ I successfully compiled a UDF about DPM using "Transient Calculation". During the calculation： the error appeared as shown below: Error: received a fatal signal（segmentation fault） Error: received a fatal signal（segmentation fault) Error object:#f I checked the code and I think it's right. who can help me? Thanks!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error: received a fatal signal (Segmentation fault). Error Object: #f	Naveen Kumar Gulla	FLUENT	0	May 18, 2018 14:12
fatal signal segmentation fault in a UDF	hares	FLUENT	6	January 21, 2017 03:26
Erron: FLUENT received fatal signal (ACCESS_VIOLATION) in DPM Heat and Mass Transfer	Melvin	FLUENT	2	November 17, 2016 01:06
FLUENT received fatal signal (ACCESS_VIOLATION) Error	jreiter164	Fluent UDF and Scheme Programming	3	February 16, 2015 13:19
Fluent received fatal signal (ACCESS_VIOLATION)	sravan451	Fluent UDF and Scheme Programming	5	May 10, 2011 23:37

All times are GMT -4. The time now is 14:25.