|
[Sponsors] |
July 16, 2021, 05:47 |
Obtain boundary face values for a cell
|
#1 |
New Member
qntldoql
Join Date: Sep 2020
Posts: 15
Rep Power: 5 |
I have read the UDF manual multiple times and also searched the forum, but could not find a solution.
For a 2D domain (rectangular), for each cell inside the domain (away from the walls) I want to obtain the temperature of the bottom wall at their corresponding cell x-location. Is there a way to do this? What I have currently done is to save the first-layer cell centroid temperature values and the temperature gradients to calculate the wall temperatures. (But for each cell, to obtain appropriate wall temperature, it would have to iterate through all the saved values of wall temperature to obtain correct x-location, thus very time consuming). |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary condition: check all cell values normal to the face of patch | agustinvo | OpenFOAM Programming & Development | 3 | May 1, 2021 06:00 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |