|
[Sponsors] |
February 17, 2011, 07:31 |
Display boundary condition defined by UDFs
|
#1 |
Member
|
Hi Everyone,
I have problem this Fluent software. Because my boundary condition was defined by UDFs (parabolic profile velocity), I want to check accuracy it by interface graphic. How can I display it in the interface graphic of Fluent? Thanks in advance. |
|
Tags |
boundary conditions, udfs |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Slip flow boundary condition on wall using UDFs | mahdi haddad | FLUENT | 1 | November 11, 2014 06:13 |
inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 08:56 |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 11:32 |
how to set up a wall boundary condition according to calculated wall shear stress? | gameoverli | OpenFOAM Pre-Processing | 1 | May 21, 2009 08:28 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |