|
[Sponsors] |
What is the cuase of dynamic mesh no working? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 18, 2011, 03:04 |
What is the cuase of dynamic mesh no working?
|
#1 |
New Member
sutthinan
Join Date: Feb 2011
Posts: 9
Rep Power: 15 |
Hi Everyone,
I need to make the wall where is deformed by pressure, then I write the UDF code DEFINE_GEOM(deform, domain, dt, position) to define the boundary moving of wall. Everything look fine, but the meshes in side close to boundary were not moving properly, only the boundary is moved. So I quite doubt with this. I used dynamic mesh-- layer (height base) and mesh element type is Quad Many thanks, Sutthinan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
Regarding Negative volume detected in Dynamic mesh | Vinay Morabad | FLUENT | 10 | December 16, 2015 00:31 |
[mesh manipulation] Dynamic Mesh Diffusivity Problem | dancfd | OpenFOAM Meshing & Mesh Conversion | 0 | August 29, 2010 11:50 |
Dynamic mesh - structured mesh | mrestrepo30 | FLUENT | 0 | June 3, 2009 15:40 |
dynamic mesh not working | studentwhoneedshelp | FLUENT | 4 | July 24, 2008 03:31 |