|
[Sponsors] |
June 12, 2012, 11:07 |
y+ wide range 0.5 - 90
|
#1 |
Senior Member
Join Date: May 2011
Location: Germany
Posts: 130
Rep Power: 15 |
Hi,
I am facing new problem with a new meshing tool. When I run my simulation I get a wide range of y+ (0.5 - 90). My problem now is which wall function should I use. I am using realizable k-epsilon.... I know, that for standard wall function y+ should be in the range of 30.... 300. But can enhanced wall function handle my problem? I can handle the y+ value at the area where I am most interested, but not for the whole mesh. Hope you guys have any advice. Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 6 | June 19, 2017 14:12 |
[blockMesh] grading in the BlockMesh | Astarta | OpenFOAM Meshing & Mesh Conversion | 1 | May 23, 2011 15:39 |
[blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 0 | April 7, 2011 11:09 |
[blockMesh] Blockmesh error - 2D scramjet | ishaninair | OpenFOAM Meshing & Mesh Conversion | 7 | March 18, 2011 00:14 |
LiftDrag tool | nuovodna | OpenFOAM Running, Solving & CFD | 45 | September 2, 2009 17:56 |