|
[Sponsors] |
Reset flow-time, time-step & iter. counter while maintaining data?? Help please |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 19, 2012, 18:33 |
Reset flow-time, time-step & iter. counter while maintaining data?? Help please
|
#1 |
Member
Join Date: May 2010
Posts: 57
Rep Power: 16 |
Hi all,
Recently I've had a problem where due to single precision the pistons of the Stirling engine I'm modelling didn't return to their exact starting locations after one shaft revolution. As a result, my starting point "moved" in time by about 107 time-steps. Is there anyway I could make this point 0 (flow-time, time-step and iter. no.) while keeping the data? I tried interpolating and (rpsetvar'flow-time 0.0) but didn't work. After interpolating/reading the results the pressure values were wrong and rpsetvar reset the flow-time but kept the iteration count the same. I would like to save snapshots of my solution every 250 time-steps and FLUENT saves at 250, 500, 750 etc while in my case it should now be smth like 357, 607, 857 etc which i cannot specify in the solution animation settings. Any ideas would be greatly appreciated! Best, |
|
April 20, 2014, 07:00 |
|
#2 |
Senior Member
Astio Lamar
Join Date: May 2012
Location: Pipe
Posts: 186
Rep Power: 14 |
Type in the TUI:
solve montiors residual reset yes or save data file using Interpolation. Initialize the case and read the interpolated file. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Physical Reason for stability of Implicit Schemes? | radhakrishnan | Main CFD Forum | 26 | October 3, 2023 22:05 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Time step, Number of time step, Maxximum Iterations per time step | sandisk | FLUENT | 0 | July 18, 2011 02:57 |
calculation diverge after continue to run | zhajingjing | OpenFOAM | 0 | April 28, 2010 04:35 |
How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |