|
[Sponsors] |
May 2, 2013, 11:29 |
Pressure inlet of a multiphase model
|
#1 |
New Member
Join Date: Apr 2013
Posts: 11
Rep Power: 13 |
Hi,
I am modeling a liquid injection into a cylinder of constant volume. I set the boundary condition of the inlet as pressure inlet (9bar). There's no outflow of my system since I expected the liquid jet to cool and condensate the vapor phase (4bar) in the cylinder. However, no matter how I changed other parameters, the pressure of the mixture in the cylinder would become 9bar immediately after the first iteration. Back flow was also noticed around the inlet. And there was no phase change. But when I change the inlet condition into a velocity inlet, everything turns okay (at least until now). What is wrong with this? Why can't I use the pressure inlet condition? Thank you in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"Pressure Inlet" Boundary Setup | Wijaya | FLUENT | 15 | May 18, 2016 10:08 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
Unsteady pressure differential between inlet and outlet of the pipe for single phase | joshi20h | FLUENT | 0 | September 26, 2012 12:41 |
Setting pressure and velocity in inlet | Asghari | FLUENT | 5 | September 22, 2006 13:23 |