|
[Sponsors] |
May 14, 2013, 11:00 |
Sc-CO2
|
#1 |
New Member
tien
Join Date: May 2013
Posts: 12
Rep Power: 13 |
I'm simulating the flow of Sc-CO2 through a capillary nozzle with these parameters:
pressure inlet: 1.5*10^7 pa temperture inlet: 350 K outlet is atmospheric condition I'm using EOS for real gas. however I can't set the pressure for inlet boundary conditions, instead, I use velocity. so, my question is how to set the supercritical properties for the flow? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error: update_absorption_coefficient: CO2 not defined | NormalVector | FLUENT | 4 | August 7, 2019 16:43 |
CO2 concentration simulation | angierain | CFX | 7 | May 2, 2016 16:51 |
Adding CO2 Mole Fraction to buoyantBoussinesqPimpleFoam | NJG | OpenFOAM Programming & Development | 4 | February 11, 2013 07:33 |
Ventilation to reduce the CO2 concentration | saisanthoshm88 | CFX | 1 | March 29, 2012 23:46 |
Problems with defining high initial concentrations of CO2 | Lizzz | FLUENT | 0 | August 11, 2010 05:34 |