|
[Sponsors] |
July 26, 2013, 01:56 |
solution is converged but a problem
|
#1 |
Senior Member
FHydro
Join Date: Jan 2013
Posts: 197
Rep Power: 13 |
''Hello
I am modeling an open channel flow with two inlet for air and water (velocity inlet). Without using "Open channel flow" In middle of channel i have two pressure inlet for entraining air into the flow. In steady state, i do not have problem but in unsteady state, i ran the solver and everytime the flow arrive to middle of channel, fluent write: "solution is converged" but it is keeping the solve and does not stop. what is that problem? I should say the residuals are arriving to residual criteria and they are 0.001 for all please see attached image Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence | Centurion2011 | FLUENT | 48 | June 14, 2022 23:29 |
Unable to get converged solution using SimpleFoam | jr33 | OpenFOAM Running, Solving & CFD | 6 | December 12, 2016 04:48 |
Solution converged after 1 iteration!! | mecarlg | FLUENT | 1 | April 12, 2010 11:02 |
Calculate a converged flow solution | kumar | FLUENT | 2 | May 24, 2007 01:33 |
Numerical solution to the rotating disk problem? | johny | Main CFD Forum | 7 | September 5, 2005 05:53 |