|
[Sponsors] |
December 3, 2013, 23:29 |
co-axial double pipe heat exchanger
|
#1 |
New Member
manish
Join Date: Dec 2013
Posts: 2
Rep Power: 0 |
i am following a tutorial on double pipe exchanger available athttp://homepages.wmich.edu/~leehs/ME...20tutorial.pdf
i have tried lot of time but the solution doesnt converges but the tutorial says it should converge within 650 itrations. i need help to simulate double pipe in ansys fluent please help |
|
December 4, 2013, 03:34 |
|
#2 |
Member
|
Hi,
Did you follow up the same steps as per the tutorial. Changing mesh sizes would also affect the convergence |
|
December 4, 2013, 04:04 |
|
#3 |
New Member
manish
Join Date: Dec 2013
Posts: 2
Rep Power: 0 |
Yes i have done the meshing as per instruction but solution not converging...recomend me some other tutorial , if you know any
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] double pipe heat exchanger meshing in ICEM CFD | chitra | ANSYS Meshing & Geometry | 0 | April 13, 2013 08:36 |
Linux vs PC Compiling | Rhyno466 | Fluent UDF and Scheme Programming | 10 | May 11, 2012 17:01 |
UDF for Heat Exchanger model | francois louw | FLUENT | 2 | July 16, 2010 02:21 |
pipe in pipe heat exchanger | JohannV | FLUENT | 3 | December 3, 2009 02:53 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |