|
[Sponsors] |
December 9, 2013, 12:59 |
2d axisymmetric
|
#1 |
New Member
sa
Join Date: Jul 2012
Posts: 23
Rep Power: 13 |
Hi everyone,
I drew 3-D cylinder and I am going to draw 2-d axisymmetric of the cylinder. would you please give me some suggestion how can I do it in ANSYS FLUENT? Thanks |
|
December 9, 2013, 14:22 |
|
#2 | |
Senior Member
Jamal Foroozesh
Join Date: Oct 2012
Location: Iran
Posts: 162
Rep Power: 13 |
Quote:
note that lengh of rectangular must be parallel to x axis. I hope this help you. Best regards Jamal |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] 2D axisymmetric simulation starting with a 2D fluent msh file.... How ? | vishalsacharya | OpenFOAM Meshing & Mesh Conversion | 0 | November 17, 2011 00:29 |
Difference of final temperature between a plane and an axisymmetric geometry | douchka | FLUENT | 0 | July 7, 2011 08:38 |
Convertation axisymmetric cases from Fluent to OpenFOAM | Svensson | OpenFOAM | 0 | April 19, 2011 06:08 |
Level set equation in axisymmetric 2-D flow | jinwon park | Main CFD Forum | 0 | February 26, 2008 16:26 |
Axisymmetric Flow | S. Kumar | Main CFD Forum | 0 | November 10, 2001 10:15 |