|
[Sponsors] |
April 8, 2014, 11:22 |
FSI thin elastic flap error!!
|
#1 |
Member
Samer
Join Date: Jan 2013
Posts: 31
Rep Power: 13 |
Dear All
I am trying to setup FSI case by coupling Fluent with structural solver using system coupling in workbench, my domain is a rectangular duct where there is inside a cantilever beam, however whenever i assign a low thickness for the cantilever beam for example 0.03 mm, the data transfer in system coupling are not mapped, i get 0 percent area mapping, anyone know how to resolve this? this only occurs when i put low thickness, in large thickness, it works fine.... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |