|
[Sponsors] |
May 14, 2014, 13:38 |
problem with slidingmeshes
|
#1 |
New Member
sairam
Join Date: Oct 2013
Posts: 7
Rep Power: 12 |
I am trying to simulate train-tunnel interactions in 2D. I attached the two domains i am using and the boundary conditions imposed. i solved compressible navier stokes equation.used every turbulent model that's there in fluent. The problem is that i couldn't capture the pressure variations as were in papers which i monitored at various points on the tunnel. i couldn't figure out what the problem is.
Used sliding mesh for train domain and tunnel cell zone is kept stationary. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |