|
[Sponsors] |
May 15, 2014, 02:02 |
Strange problem with chem. reaction
|
#1 |
New Member
Alexey
Join Date: Jan 2014
Posts: 18
Rep Power: 12 |
Hey, i am modeling 3d reactor with chem. reaction, but I ran into some difficulties.
Concentration is changing very rapidly near the inlet, and then becomes constant. Then I made a 2d version (very fine mesh). 270000 quadrilateral cells, zone 2, binary. 90 2D mass-flow-inlet faces, zone 3, binary. 90 2D outflow faces, zone 4, binary. 2220 2D wall faces, zone 5, binary. 538800 2D interior faces, zone 7, binary. 271201 nodes, binary. 271201 node flags, binary. Result (click to zoom in) So, there is a small layer near inlet, where concentration is changing. I tryed different boundary and different reaction - result is the same. WhenI modeled the reaction in a tube, results were better |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange Flamelet Generation Problem | tar | FLUENT | 11 | March 22, 2014 10:52 |
Re: Strange Problem in Temperature Contour, continuity residual | yashganatra | Fluent UDF and Scheme Programming | 0 | June 27, 2013 09:17 |
CFX5.7 - chemical reaction problem... | H.L. | CFX | 4 | March 25, 2009 10:33 |
strange problem.... | Vivek | FLUENT | 0 | September 29, 2007 13:28 |
chemical reaction - decompostition | La S. Hyuck | CFX | 1 | May 23, 2001 00:07 |