|
[Sponsors] |
May 27, 2014, 09:48 |
Time Step sizing
|
#1 |
Senior Member
AH
Join Date: Apr 2014
Posts: 282
Rep Power: 13 |
Understand the sizing of time step, as per manuals. Typical Cell Size /characteristic velocity...
But if I was to simulate a flow condition over 48 hours, is it wrong to divide the 48 hours over for an example 10 steps. Time step = 48/10 (then convert to seconds). This will give me a flow simulation over 24 hours. Please let me know what you think thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
number of iterations per time step | chouki | FLUENT | 1 | August 13, 2013 00:11 |
Full pipe 3D using icoFoam | cyberbrain | OpenFOAM | 4 | March 16, 2011 09:20 |
calculation diverge after continue to run | zhajingjing | OpenFOAM | 0 | April 28, 2010 04:35 |