|
[Sponsors] |
April 1, 2015, 05:56 |
Define_Profile() position in loop
|
#1 |
New Member
Join Date: Oct 2009
Posts: 25
Rep Power: 16 |
I'm not sure about the position of Define_Profile() position in the Solution Procedure loop.
Is it executed at the same time as Update Properties macros past Solver and before Define_Adjust() macro? What would happen if for instance the temperature of the same zone is set in Define_Profile() and Define_Adjust() macros? Which values take effect? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[CAD formats] my stl surface is seen as just a line | rcastilla | OpenFOAM Meshing & Mesh Conversion | 2 | January 6, 2010 01:30 |
DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 01:29 |
NACA0012 geometry/design software needed | Franny | Main CFD Forum | 13 | July 7, 2007 15:57 |