|
[Sponsors] |
1. Create new material 2. put a static fluid in pipe |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 2, 2015, 06:05 |
1. Create new material 2. put a static fluid in pipe
|
#1 |
New Member
Yu Lu
Join Date: Jul 2015
Location: England
Posts: 26
Rep Power: 10 |
Hi all
I'm a very new user of Ansys. I was trying to create new material in Fluent (basically Borosilicate glass and silicone oil). How can I do this? Also if I want to simulate a process that a fluid is introduced to a pipe where the pipe is filled with a static fluid already (different fluid from the one being injected),How can I do this? Thanks a lot for any suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error in Two phase (condensation) modeling | adilsyyed | CFX | 15 | June 24, 2015 19:42 |
Compression stoke is giving higher pressure than calculated | nickjuana | CFX | 62 | May 19, 2015 13:32 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
About create new material | jasonchang | CFX | 3 | May 18, 2006 21:07 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |