|
[Sponsors] |
June 30, 2015, 07:42 |
Advices for boundary conditions - fluent
|
#1 |
New Member
Join Date: Jun 2015
Posts: 11
Rep Power: 11 |
Hello everybody,
I am trying to modelise a water flow through an analyse chamber. It is a diphasic problem because this chamber is initially full of air, and because of its geometry, some air bubbles stay during the flow (it is even important that it stay). For inlet, I have water with a given pressure (that I need to change for each calculation, my job is to determine how this pressure influence the water behaviour). For outlet, there is a pump installed after the chamber, who suck up with a debit of 6L/h. I am not using Ansys (Fluent) for a long time, so i need some advices concerning the boundary conditions and I have a few questions.. For boundary condition, I am using velocity inlet and pressure outlet because it is only with that that I have results yet. But I am perplexed and I am not sure that describes well my problem. For the other questions ... : - how I can take in account the compressibility of air ? - what i am supposed to put in operating density ? (I currently use 998.2, the water's density, and it works I think, but I don't understand why...) - I definitely don't understand the difference between the operating pressure, the initial gauge pressure, the pressure we put on velocity inlet and the pressure we put on pressure outlet, etc... If anybody want to tell me to go see the fluent user's guide, I have already done that and that didn't help me (or at least not anymore ^^') Thanks a lot for your advices, all comments will be helpfull ! And if you have any question about the configuration of my problem do not hesitate.. I am very sorry for my poor english by the way .... |
|
July 6, 2015, 07:28 |
|
#2 |
New Member
Join Date: Jun 2015
Posts: 11
Rep Power: 11 |
Ok, now I just need to have an inlet pressure with a precise outlet flow rate (6L/h) ... Is there a way to do that with fluent or something else ..? (CFX perhaps ?)
I really need some help ^^' Thank you.. Last edited by mido66; July 10, 2015 at 05:25. |
|
July 10, 2015, 05:28 |
|
#3 |
New Member
Join Date: Jun 2015
Posts: 11
Rep Power: 11 |
Nop ? Nobody ?
It find that weird that we can't do such a simple thing on Fluent ... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
swept back wing: how and which boundary conditions to use in Fluent? | Silver Silhouette | FLUENT | 7 | April 10, 2015 13:50 |
Drawbacks of FLUENT if any-handling interfacial boundary conditions? | dnaneet | FLUENT | 2 | April 27, 2014 16:07 |
Problem in using parallel process in fluent 14 | Tleja | FLUENT | 3 | September 13, 2013 10:54 |
Fluent boundary conditions | Tony | FLOW-3D | 1 | December 4, 2008 00:39 |
Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 06:25 |