|
[Sponsors] |
July 14, 2015, 22:19 |
Making Internal Face Boundaries
|
#1 |
New Member
anonymous
Join Date: Apr 2015
Posts: 7
Rep Power: 11 |
Hi All,
So in a follow up to my post about creating an actuator disk in Fluent, I'm trying to create an interior face boundary in FLUENT and I am not sure how. First off is it even possible to create such a thing? Basically what I want is just a face at which I can assign a given pressure value. Is that something FLUENT can handle, or is it beyond FLUENT's capabilities? If anyone could point me to any resources on this topic I would very much appreciate it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
[Workbench] Named selection for internal face not appearing in CFX-Pre | francis1 | ANSYS Meshing & Geometry | 0 | April 21, 2013 09:22 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |