 |
 |
 |
|
|
|
[Sponsors] | ||||
August 3, 2015, 06:04
|
Mass flow
|
#1 |
|
Senior Member
Gustavo
Join Date: Jun 2015
Posts: 121
Rep Power: 10  |
Hi,
Iīm facing a Problem with the flow rate results from my Simulation. I have a gasfeed (both sides closed), square sectional area. The inlet is in the middle on the bottom and I have some holes in the top equidistant. When I calculate the flow rate in each hole with the funtion calculator I observe that itīs not symmetric. The Operating Condition is 1 Pa; pressure outlet 0 Pa, velocity inlet = 0,08 m/s. In attach you can find a sketch. Could someone help me? thanks |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
| mass flow inlet and pressure outlet with target mass flow rate | Zigainer | FLUENT | 13 | October 26, 2018 05:58 |
| Convergence problem with target mass flow rate | ADL | FLUENT | 2 | May 29, 2012 21:11 |
| mass flow | Wenbin Song | FLUENT | 0 | September 27, 2005 13:00 |
| Mass Flow Inlet | Pravir Kumar Rai | FLUENT | 0 | February 19, 2003 14:03 |
Threaded Mode
