|
[Sponsors] |
August 9, 2015, 08:55 |
heat flux
|
#1 |
New Member
behnamrha
Join Date: Jun 2015
Posts: 14
Rep Power: 10 |
hi
i have have solid Cylindr in a cube. i generated the geometry and mesh in icem. when i wanna set boundry condition in fluent in the part heat flux ,i should be set thickness of wall' what is job about this . |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Total heat transf. rate vs Total surface heat flux | Renato Sousa | FLUENT | 1 | April 14, 2020 03:27 |
Wall Heat Flux & Temperature | Greg Perkins | FLUENT | 10 | November 20, 2015 09:32 |
Forced convective heat transfere with fixed heat flux? | BenFranklinIII | OpenFOAM Running, Solving & CFD | 0 | July 30, 2015 05:31 |
Enforce bounds error with heat loss boundary condition at solid walls | Chander | CFX | 2 | May 1, 2012 20:11 |
Negative Heat Flux | shashank312 | FLUENT | 3 | December 9, 2011 17:00 |