|
[Sponsors] |
December 18, 2015, 13:09 |
Fluent 3D pipe flow
|
#1 |
New Member
Join Date: Dec 2015
Posts: 2
Rep Power: 0 |
I have created a 3d pipe flow problem for water in Fluent and solved it setting the flow to laminar, i am only interested the wall shear stress on one of the surfaces. When i solve i get a range of shear stresses, is it possible to get specific values?
the inlet velocity is 0.0005m/s and the outlet is pressure |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
Nu values come up too high for cylindrical pipe turbulent flow | Onur10 | FLUENT | 7 | February 21, 2016 12:59 |
Fluent v15 multiphase flow b.c. failure Non-channel flow | mickjazz | Fluent Multiphase | 1 | September 22, 2014 06:41 |
Two-phase flow in a circular horizontal pipe | DmitryS | Fluent Multiphase | 0 | May 17, 2014 16:22 |
setup problems - LES pipe flow with cyclic BC (1) and direct mapped inlet (2) | florian_krause | OpenFOAM | 22 | June 13, 2013 21:25 |