|
[Sponsors] |
January 8, 2017, 21:52 |
Viewing section plan in setup window
|
#1 |
New Member
Tom Mark
Join Date: Jan 2014
Posts: 4
Rep Power: 12 |
I model a 3d geometry in ANSYS Design-modeller, and i created a section of it using section plan tool, after meshing, the model is still appearing as a whole in the setup window, i was expecting half of it to come up in the setup window to run my simulation. What I'm suppose to do to get half of it in my setup window after creating a section plan in the mesh window?
Tom |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2D Glass Melt Simulation Setup | marmz | FLUENT | 5 | October 9, 2016 15:25 |
Gambit Startup Window | Jay Shim | FLUENT | 2 | February 12, 2015 14:05 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
LiftDrag utility from v12 to v141 | cfdphil | OpenFOAM Running, Solving & CFD | 2 | December 5, 2007 05:49 |
New section and new gateways | Ynot | CFD-Wiki | 7 | December 17, 2005 13:21 |