Editting or Viewing *.msh file in Fluent

Bashar · January 18, 2017, 09:07

Hi,

I was working on a case in ANSYS then I saved the mesh as an *.msh. Unfortunately, I lost the original case files and I just have the *.msh file. I tried to open it using Fluent but it didn't even open the file , it just imported it . I searched the forum and I found suggestion to open the mesh file using FE Modeler in ANSYS. Again I have an error message "invalid fluent mesh format".

Is there any way that I can open the msh file in order to see the setting of the mesh?

Bashar

Kushal Puri · January 20, 2017, 12:17

Quote:

Originally Posted by Bashar

Hi,

I was working on a case in ANSYS then I saved the mesh as an *.msh. Unfortunately, I lost the original case files and I just have the *.msh file. I tried to open it using Fluent but it didn't even open the file , it just imported it . I searched the forum and I found suggestion to open the mesh file using FE Modeler in ANSYS. Again I have an error message "invalid fluent mesh format".

Is there any way that I can open the msh file in order to see the setting of the mesh?

Bashar

Try to open in ICEM CFD or Hypermesh and export again. Or try to open in fluent meshing mode

January 18, 2017, 09:07	*Editting or Viewing .msh file in Fluent**	#1
Bashar Member Bashar Join Date: Jul 2015 Posts: 74 Rep Power: 10	Hi, I was working on a case in ANSYS then I saved the mesh as an .msh. Unfortunately, I lost the original case files and I just have the .msh file. I tried to open it using Fluent but it didn't even open the file , it just imported it . I searched the forum and I found suggestion to open the mesh file using FE Modeler in ANSYS. Again I have an error message "invalid fluent mesh format". Is there any way that I can open the msh file in order to see the setting of the mesh? Bashar

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] How to use finite area method in official OpenFOAM 2.2.0?	Detian Liu	OpenFOAM Meshing & Mesh Conversion	4	November 3, 2015 03:04
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0	Seroga	OpenFOAM Community Contributions	9	June 12, 2015 17:18
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24