|
[Sponsors] |
April 25, 2017, 01:56 |
Start/stop sampling - Journal file
|
#1 |
Senior Member
SinaJ
Join Date: Nov 2009
Posts: 136
Rep Power: 16 |
Hi,
I'm trying to use "start" and "stop" for DPM sampling using journal files. I would like to select the injections, and surfaces on Fluent with GUI, and even press on "start" for sampling. Then save the case and data files, run it in batch mode, and in the journal file, "stop" the sampling before saving the case/data file and finishing the job. What commands can I use for start/stop sampling in journal file? Thank you |
|
April 25, 2017, 09:44 |
|
#2 |
Senior Member
SinaJ
Join Date: Nov 2009
Posts: 136
Rep Power: 16 |
any suggestions?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] funkyDoCalc with OF2.3 massflow | NiFl | OpenFOAM Community Contributions | 14 | November 25, 2020 03:30 |
polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |